![]() While they are often additionally used as measuring devices, the main purpose of a fid is to allow the user a means to manipulate the strands of a rope in order to complete a splice. Through the ages, fids have been made from bone, wood, plastic and steel in the form of wire, tubes and rods. Then repeat the milking procedure.Fids are one of the most important tools utilized in the splicing of rope. If this happens, slide the cover slack back toward the knot until the crossover is the proper size. In Step #9 if insufficient tension is placed on the rope while milking up the slack the crossover may tend to bunch up.If the core appears to be stuck, pull the Uni-Fid back until the core is no longer snagged and continue. If the core moves freely it is OK to proceed. To check if the core has been snagged, pull on the exposed core where it exits from the cover at Mark “B”. Avoid snagging the core with the tip of the fid when it is passing through the cover in the vicinity of Mark “B”.Then continue working the fid through the cover to Mark “D”. Slide the cover slack back from the fid to Mark “C” to draw the core tail into the cover. If the distance between “C” and “D” is longer than the length of the fid, hold the fid in place by squeezing it through the cover braid.This will cause the cover to “pucker” and give you some extra space. To create more space in this area, grasp the core as it exits the cover at point “B” and pull extra core out of the rope. The rope may be extremely tight where the fid is traveling between Marks “C” and “D”.For a thimble without ears: insert thimble into eye before final burying of splice. The eye splice is then completed in a normal fashion with one exception: before final bury, slide the thimble around to cover side of eye. Extract the core and insert the core through the bale or around the shackle as illustrated. To splice into a thimble with ears, shackle, or similar item, simply follow the directions of the splicing instructions, using the thimble or shackle bale to determine the eye size. Seize or cross-stitch the eye to finish the splice. Flex and/ or hammer the splice section to loosen the fibers. Milk the cover from the crossover around the radius of the eye to the throat at “B” and pull that leg sharply with a spike to help seat the splice. This is accomplished by holding the rope at the top of the eye and sliding the slack back from the knot towards the splice. The slack in the cover braid between the knot and Mark “B” will be used to bury the exposed core, crossover and cover down to Mark “A” to produce the desired size eye. Step #9: Secure the knot tied in the body of the rope to a solid anchorpoint. The ex- posed core will disappear completely inside the cover. 7) Hold the rope at the crossover and smooth the cover braid from the crossover toward Mark “D”. Cut the strands at a 45 degree angle starting at a point about halfway back from the end. 7) Cut off the excess core tail at the first mark (the one near- est the end of the core) and unbraid the core tail back to the second mark. 6) Pull out the core tail at Mark “D” until the mark made at “B” appears. Then mark the core tail at Mark “B” by inserting the marking pen into the opening at Mark “B”. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |